Maintenance And Care - Reely Hydro Force Notice D'emploi

12.

Maintenance and Care

Regularly check the drive and control functions of the electronics at your model. All moving parts have to be easily
movable but there should not be a clearance in the bearing.
The outside of the model should only be cleaned with a soft, moistened cloth. Never use any aggressive cleansing
agents or chemical solvents, since this might damage the surfaces.
Important!
If you have to replace any damaged or worn parts, only use original replacement parts.
The spare parts list is located on our website www.conrad.com in the download section to the respective
product.
Damage to the boat's body should only be repaired with suitable instant glue that is also suitable for fibreglass-
reinforced plastics but not water-soluble. We recommend 5-minute epoxy glue.
The drive shaft must be regularly lubricated. This is usually announced by more water than usual being in the boat
body after a voyage and/or by the drive running roughly.
Completely remove the drive shaft at such signs by loosening the hexagon socket screw of the shaft tappet at the
motor, removing the motor and pulling it off of the shaft tappet. Then remove the ship's propeller along with the shaft
securing ring. Last, the drive shaft can be pulled out inwards.
Grease the drive shaft with a bio-degradable grease and reinstall it in the reverse order. Screw connections metal/
metal must be secured with a drop of threadlocker varnish.
51