Reconnecting; Re-Pairing; On / Off Switch - Marmitek BOOMBOOM 50 Mode D'emploi

2. Put your Bluetooth headphones in pairing mode (please refer
to your headphones' user manual).
3. Connect the BoomBoom 50's USB connector to a USB port
on your TV or possibly use a USB power adapter (not
supplied).
4. The BoomBoom 50 will now be automatically paired with
your headphones. Once the pairing has been established,
the blue LED on the BoomBoom 50 will light up continuously
(this may take a while).
5.3

Reconnecting

Whenever the BoomBoom 50 or your headphone has been
switched off, the BoomBoom 50 will automatically reconnect as
soon as the BoomBoom 50 and the headphones are turned back
on again.
5.4

Re-pairing

To re-pair the BoomBoom 50 with another set of Bluetooth
headphones.
Press and hold the "pairing" button on the BoomBoom 50 for 0.5
seconds. Any previously paired device will be deleted. The
BoomBoom 50's red/blue LED will flash and the BoomBoom 50
will automatically make a connection with a set of Bluetooth
headphones that are in pairing mode.
5.5

ON / OFF switch

If you want to turn off the BoomBoom 50, press the button for 2
seconds. Would you like BoomBoom 50 on again, then you press
the button for 2 seconds.
8 © MARMITEK