Chain Counter Setting Menu - MZ electronic HC020 Instructions D'utilisation

Windlass / Capstan mode
HC020 chaincounter has two different operating modes: Windlass mode and capstan mode:
ARRESTO
WINDLASS
When the device is turned on it is set in windlass mode, which is standard operating mode by default: it is
possible to operate the windlass obtaining lowered chain meters, chain speed and sensor error in case of
faults on the sensor installed on the windlass.
In capstan mode, capstan is put in motion for standard mooring operation, without sensor reading; this
way, the chain length doesn't change, chain speed is not displayed, and no sensor signal is given as it is
not used when the chain is not in motion.
In order to shift from one mode to the other one, you need to press the button
seconds to make the icon change mode appear:
Release the button
capstan and vice versa.

Chain counter setting menu

Hold down the
to access the instrument setting menu. The
following page will appear on the display:
Use the (DOWN) and
move around the menu options.
Once you are positioned on the item to be modified press the
choice.
Use the (DOWN) or
Once one is positioned on the parameter press the
HC020
m
3.2
0 mt/m
13.6V
(ON) when the icon appears in order to do the mode change from windlass to
(ON) key for six seconds
(UP) keys to
(UP) keys to move from one parameter to another.
ARRESTO
3.2
TONNEGGIO
13.6V
MENU
WORKING MODE
MEASURE
FUNCTIONS
SETTINGS
SENSOR
CAN
(ON) key to confirm your
(ON) key to enable modification.
22
English
m
CAPSTAN
(ON) for about 3
Rev. 03-2021