MZ electronic HC020 Instructions D'utilisation page 24

Reset Measurement
Resets the chain measurement value (0.0).
Units
Selects the unit of measurement:
Feet/ inches
Metres / centimetres
Exit
To return to the settings menu.
Functions menu
Use the (DOWN) or
Up Alarm
It is possible to enable the function and
establish the height at which the anchor-
winch stops; after which it is only possible to
give pulsed commands.
Settable values: OFF, 0.5 – 1.0 – 1.5 – 2.0 –
2.5 - ... 10.0 (metres or feet).
Auto Down
Enables the automatic anchor lowering
procedure, at the desired height, with the
pressing (for at least 3 seconds) of the keys
and .
Settable value: OFF, 1,2,3...25 (metres or
feet).
Load Default
This function allows the User to revert to the
original factory default settings, thus erasing
all settings memorised.
This command must only be used in the
event of programming errors.
HC020
Select with
Confirm with
Select with
Confirm with
Confirm with
FUNCTIONS
UP ALARM
AUTO DOWN OFF
DEFAULT
EXIT
(UP) key to move around the parameters.
Select with
Select value with
Confirm with
Select with
Select value with
Confirm with
Select with
Confirm with
= Yes = No
= Feet = Metres
2.5
= Yes = No
24
English
Rev. 03-2021