MZ electronic HC020 Instructions D'utilisation page 26

Sensor menu
Use the (DOWN) or
Sensor
This function selects the sensor type:
•
2-wire standard sensor (STD)
•
3-wire electronic sensor (HAL)
Barbotin
The circumference of the gypsy must be
entered in this row (in centimeters or inches).
To enter the correct value see the paragraph
"instrument calibration"
Divisor
If the standard 2-wire electronic sensor
(STD) is used, this value must be left at 1. if
an electronic sensor is used it must be equal
to the number of sensor pulses for each turn
of the barbotin. See paragraph "Instrument
calibration".
Test
This function allows you to check the correct
operation of the tachometer sensor: a screen
with the status of the sensor is displayed: by
rotating the winch, the contact must close
when the mangete passes in
correspondence with the sensor, closing it.
Exit
To return to the previous menu.
HC020
SENSOR
SENSORE
BARBOTIN
DIVISOR
TEST
EXIT
(UP) key to move around the parameters.
Select with
Select value with
Confirm with
Select with
Select value with
Confirm with
Select with
Select value with
Confirm with
Confirm with
STD
33.0
1
SENSOR
26
English
Rev. 03-2021