Installing The Chain Counter - MZ electronic EV-011 Instructions D'utilisation

Installing the chain counter

(see connection diagram)
Warning
ALWAYS DISCONNECT THE BATTERY PRIOR TO
INSTALLATION.

The chain counter must be positioned so that the display will be easy to read. It
should not be exposed to direct sunlight.

The rear part of the instrument must be protected from contact with water or moisture.

The instrument may be fastened to dashboards whose thickness is more than 6 mm
(~1/4"). In order to fasten it, please employ M3 x 5 screws for 6 mm (~1/4")
dashboards. For bigger thickness please use M3 screws whose length must be 2/3
mm (~1/8") less than the dashboard's thickness.

In the part to the rear of the dashboard there must be minimum clearance of 35 mm
(1" 3/8) and there must also be adequate access to perform installation and
maintenance work.

Make a hole with a diameter of 24 mm (~ 1") – max. 30 mm (~1" 3/16) – on
the dashboard and 2 holes with diameters of 9 mm
(~7/16") for the chain counter clamping screws
(see figure). Use cutting nippers to cut the three pins on
the back of the instrument, position the chain counter
and fasten it to the dashboard by tightening
the two screws. If the dashboard already
has a hole with a 54 mm (2"1/8) diameter,
it is not necessary to cut the
pins on the back.
EV-011 19
English
Rev. 11– 2017