expressed in centimeters (or inches according to the measure set) is the value which has to be entered in
the Barbotin parameters
Setting the DIVIDER in the Sensor menu: if a standard sensor is used, this value must be set to
1 while if an electronic sensor is used it must be equal to the number of sensor pulses for each turn of
the barbotin:
Use
Press the
(ON) key to activate controls and to switch on the display lighting. The display lighting
switches off 30 seconds after the last command given (adjustable default time – see "BkLight Time").
Press key
(UP) to control the anchor ascending.
Press key
(DOWN) to cast anchor.
HC020
CIRCUMFERENCE OF THE BARBOTIN
28
English
Rev. 03-2021