English
Connector and sensor holes
33,3 mm
sensore magnetico
magnetic sensor
4
min.44 mm(1"3/4)
Starting up
The chain counter features a graphic display and three keys:
(ON),
(UP) and
(DOWN).
The ON key switches on the display and enables the other two keys. It must be used to access the
parameter setting menus. For selecting the parameters to be modified and to confirm the values set. The
display backlight will switch off 30 seconds after the last command given (adjustable in the menu).
The UP key commands the hoisting of the anchor and the DOWN key casts it. When the key is released,
the action is stopped. During parameter setting, the two keys allow the User to move around the menu
and vary parameter values.
When switched on, the instrument will make a beep and the following page will appear for a few seconds:
HC020
CHAINCOUNTER
Once the initialisation procedure is complete, the main page will appear.
HC020
20
Rev. 03-2021