Instrument Calibration - MZ electronic HC020 Instructions D'utilisation

Test menu
Use the (DOWN) or
LCD Test
This function switches on all the display's
pixels thus making it possible to perform a
check on them.
Software Version
Indicates the version of the software installed.
Work Hours
Indicates the hours of operation of the winch.
Exit
To return to the settings menu.

Instrument calibration

Before using the instrument the following parameters must be set:
•
UNIT OF MEASURE, (metres or feet). It can be set in the Measure menu;
•
SENSOR (2-wire standard or 3-wire electronic). It can be set in the Sensor menu;
BARBOTIN circumference setting (in cm or inches) on sensor menu: the value to be entered is the
circumference on chain winding point. If this value is not available in windlass technical records, it is
necessary to measure chain length which the gypsy can house on its circumference. This measure
HC020
TESTS
LCD TEST
SOFTWARE
WORK. HOUR
EXIT
(UP) key to move around the parameters.
Select with
Confirm with
Confirm with
1.0
0
27
English
Rev. 03-2021