MZ electronic HC020 Instructions D'utilisation page 21

COUNT
CHANGE OF MODE
SPEED
SUPPLY VOLTAGE
Where:
STATUS: indicates the status of the instrument and any failure.
UNIT OF MEASURE: shows the current unit of measure (metres or feet)
ANIMATION: an animated anchor or capstan shows the direction of the movement.
COUNT: indicates the measurement of the chain lowered (in metres or feet).
CHANGE OF MODE: this icon is displayed when there is a change in working mode (windlass mode or
capstan mode)
SPEED: indicates the chain speed during hoisting or lowering in meters per minute (mt/m) or feet per
minute (ft/m)
SUPPLY VOLTAGE: indicates the power supply voltage.
When the instrument is turned on for the first time, it will set up as programmed in the factory (see table).
HC020
STOP
Parameter
Up Alarm
Auto Down
BackLight Time
Units of measurement
Chain Measure
Barbotin Circumference
Sensor type
Language
Works Hours
Division factor
m
3.2
0 mt/m
13.6V
Default value
3.0 metres
Off
30 seconds
Metres/centimetres
0.0 metres
33 cm
Standard
Italian
0
1
21
English
STATUS BAR
UNIT OF MEASURE
ANIMATION
Rev. 03-2021