Dismounting Of Bearing 6006 On Shaft No. 1; Mounting Ball Bearings 6318 On Shaft No. 2 - SKF TMDS 6 Mode D'emploi

6.5 Dismounting of bearing 6006 on shaft no. 1

Select the correct combination of puller arms and withdrawal screw from ball bearing
puller TMMD 100, according to the instruction for the tool. Insert the arms between the
bearing rings, place the withdrawal screw in position and dismount the bearing.
7. (Dis)Mounting procedures for shaft no. 2
Shaft no.2 will show the big differences in dismounting forces between ball bearing 6315,
which is dismounted without Oil Injection Method, and ball bearing 6318, which is
dismounted with Oil Injection Method.

7.1 Mounting ball bearings 6318 on shaft no. 2

Mounting bearings with a cylindrical bore can often be done by heating them. Bearings
should be heated about 80 °C to 90 °C (179 °F to 194 °F) above the temperature of the
shaft, but should never exceed 125 °C (257 °F). To handle the hot bearings use clean gloves
(TMBA G11) or a clean lint-free cloth. Heat ball bearing 6318 on the Induction heater
TIH 030M/220V. When the bearing has reached the desired temperature, push it onto the
shaft seat without misalignment. Press the bearing inner ring against the abutment face
until an interference it is obtained.
SKF TMDS 6 11