Safety Recommendations; Ec Declaration Of Conformity - SKF TMHP 15/260 Mode D'emploi

Safety recommendations

As high pressures/forces constitute a potential safety
risk, the following instructions must be considered:
• The equipment should only be operated by
trained personnel.
• Always follow the operating instructions.
• Check the puller and all accessories carefully
before use.
Never use even slightly damaged components.
• Make sure the force rating of the puller exceeds
calculated maximum withdrawal force.
• Ensure that the puller legs are properly secured
around the workpiece.
Each claw must be fully engaged.
• Make sure the force is equally distributed in all
three arms.
• Make sure all air has been removed from the
hydraulic system, before putting the equipment
under pressure.
• Always use a pressure gauge.
• Always prevent the workpiece/tool from being
projected upon sudden release of pressure
(e.g. by use of retaining nut).
• Never use the equipment above the stated
maximum pressure.
• Use protective goggles.
• Cover the work with a protective blanket or
shield while force being applied.
• Never modify the unit.
• Use original parts only.
• Only use clean, recommended hydraulic oils
(e.g. SKF LHMF 300, LHDF 900 or similar).
• In case of any uncertainties as regards the use
of the puller, contact SKF.

EC Declaration of conformity

We, SKF Maintenance Products, Kelvinbaan 16,
3439 MT Nieuwegein, The Netherlands herewith
declare that the products described in these
instructions for use, are in accordance with the
conditions of the following directive:
Machinery Directive 2006/42/EC and are in
conformity with the following standards:
EN-ISO 12100-1,
EN-ISO 12100-2,
EN-ISO 14121-1,
EN-ISO 4413
Nieuwegein, The Netherlands, October 2011
Sébastien David
Manager Product Development and Quality
EN 3