11.
(Dis)Mounting procedures for shaft no. 6
11.1 Mounting self-aligning ball bearing 1209K on shaft no. 6
Take the shaft out of the holder. Place adapter sleeve H 209 over the shaft.
Place self-aligning ball bearing 1209EKTN9/C3 and locking washer MB 9 over the adapter
sleeve. Hand tighten the assembly with locknut KM 9.
Place the shaft and bearing assembly in its holder so that the bearing assembly its in its
housing. Tighten the nut according to the instructions of the TMHN7.
11.2 Dismounting self-aligning ball bearing 1209EKTN9/C3 on shaft no. 6
Unlock locknut KM 9 a few turns. Gently hammer against the steel block which is placed
against the bearing inner ring, so that the bearing will slide from the sleeve. The bearing
assembly is loose now and can be taken away.
SKF TMDS 6
17