Working With Temperature Control -Temp Mode Or Bearing Mode - SKF TIH 240 Mode D'emploi

«БЕРГ АБ», (495) 727-22-72, promshop-biz@ya.ru, www.promshop
3.2.3 Working with temperature control -
TEMP MODE or BEARING MODE
a) Press either
b1) If you pressed
desired heating temperature manually by using the keys
b2) The key
recommended heating temperature for bearings.
c) Press
d) Press
e) When the pre-selected temperature is reached, the heater switches
off after automatically having demagnetised the workpiece.
f) An acoustic will indicate the completed heating
cycle. This will switch off after about 10 signals or when
pressed.
g) If the workpiece is left in position, the heater will automatically start
again as soon as the temperature has fallen 10
selected value.
h) The warm keeping cycle is stopped by pressing
will anyhow be demagnetised.
i) The heater is again ready for use with same pre-selected
temperature.
«БЕРГ АБ», (495) 727-22-72, promshop-biz@ya.ru, www.promshop
SKF TIH 240
or .
, you will have to select the
will automatically choose 110
when recommended according to paragraph 3.6.
to start the heating. The actual temperature will be shown.
o o
C (230 F), which is the
is
o o
C (18 F) below the
. The workpiece
- .
11