Safety Instructions; Maintenance, Cleaning; Maintenance Work; Inspection Intervals - Burkert 2730 Manuel D'utilisation

10. MainTenance, cleaning
10.1. safety instructions
Danger!
danger – high pressure in the equipment!
• Before loosening the lines and valves, turn off the pressure and
vent the lines.
risk of injury due to electrical shock!
• Before reaching into the system, switch off the power supply
and secure to prevent reactivation!
• Observe applicable accident prevention and safety regulations
for electrical equipment!
Warning!
risk of injury from improper maintenance!
• Installation may be carried out by authorized technicians only
and with the appropriate tools!
risk of injury from unintentional activation of the system and
an uncontrolled restart!
• Secure system from unintentional activation.
• Following maintenance, ensure a controlled restart.
26
english
Type 2730 / 2731 / 2731K

Maintenance, cleaning

10.2. Maintenance work
10.2.1. actuator
The actuator of the diaphragm control valve is maintenance-free
provided it is used according to these operating instructions.
10.2.2. Wearing parts of the diaphragm
control valve
Parts which are subject to natural wear:
• Seals
• Diaphragm
→
If leaks occur, replace the particular wearing part with an appro-
priate spare part (see chapter "12. Replacement parts").
A bulging PTFE diaphragm may reduce the flow.
The replacing of the wearing parts is described in chapter
"11. Repairs".
10.2.3. inspection intervals
→
Check diaphragm for wear after maximum 10
Muddy and abrasive media require correspondingly shorter

inspection intervals!

switching cycles.
5