Authorized Use; Restrictions; Basic Safety Instructions - Burkert 2000 Manuel D'utilisation

Type 2000 INOX

Authorized use

2. AUTHORIZED USE
Non-authorized use of the angle seat valve Type 2000 INOX
(designated as device in the following) can be dangerous to
people, nearby equipment and the environment.
• The device is designed for the controlled flow-rate of liquid and
gaseous media.
• In the potentially explosion-risk area the device may be used only
according to the specification on the separate Ex type label. For
use observe the additional information enclosed with the device
together with safety instructions for the explosion-risk area.
• Devices without a separate Ex type label may not be used in a
potentially explosive area.
• Use according to the authorized data, operating conditions, and
conditions of use specified in the contract documents and oper-
ating instructions. These are described in chapter "6. Technical
data".
• Use the device only in conjunction with third-party devices and
components recommended and authorized by Bürkert.
• Correct transportation, storage, and installation, as well as care-
ful use and maintenance are essential for reliable and faultless
operation.
• Use the device only as intended.

2.1. Restrictions

If exporting the system/device, observe any existing restrictions.
3.

BASIC SAFETY INSTRUCTIONS

These safety instructions do not make allowance for any
• Contingencies and events which may arise during the installation,
operation, and maintenance of the devices.
• Local safety regulations – the operator is responsible for observing
these regulations, also in relation to the installation personnel.
Danger – high pressure!
• Turn off the pressure and vent the lines before loosening lines or
valves.
Risk of crushing from moving pneumatic connection!
• When opening and closing the device, do not touch the moving
pneumatic connection.
• Do not reach into the area immediately above and below the
control air connection.
Risk of water hammer when flow inlet over seat!
• When flow inlet over seat, do not use angle seat valve for liquid
media due to the risk of water hammer.
Risk of burns/risk of fire if used during long-term operation
through hot device surface!
• Do not touch the device with bare hands.
• Keep the device away from highly flammable substances and
media.
english
5