Instructions for installation and use
● The sauna control unit must be installed outside the sauna cabin
at a height of approx. 1.70 m, or in accordance with the rec-
ommendation given by the sauna manufacturer. The ambient
temperature must be within a range spanning -10 °C to +40 °C.
● The heater sensor must be attached in a way that ensures it is
not affected by inflow of air.
● The heater supply cable must have a minimum cross-section of
2.5 mm
and be temperature resistant up to 150 °C.
2
● Observe all regulations applicable at the installation location.
● For your own safety, consult your supplier in the event of prob-
lems that are not explained in sufficient detail in the installation
instructions.
2.3. Safety information for the user
● The just sauna fin control unit must not be used by children under
8 years of age.
● The just sauna fin control unit may only be used by children above
8 years of age, by persons with limited psychological, sensory
or mental capabilities or by persons with lack of experience/
knowledge under the following conditions:
– When they are supervised.
– When they have been shown how to use the device safely
and are aware of the hazards that could occur.
p. 7/40
EN