Installation instructions, only for experts
8.5. Activating/deactivating the foil sensor
If an infrared heat plate is connected to an additional output, a foil sensor must
be used. The foil sensor must be activated with the aid of the function selection
switch 6.
● The function selection switch 6 is set to the OFF position as standard. This ac-
tivates the foil sensor.
● If you wish to activate the foil sensor, place the function selection switch 6 in
the ON position.
8.6. Status output
The remote start function is activated or deactivated using the function selection
switch 7.
● The function selection switch 7 is set to the OFF position as standard. This ac-
tivates two-sensor mode.
● If you wish to activate the foil sensor, place the function selection switch 7 in
the OFF position.
8.7. Setting the operating mode for the additional output
The additional output can either be dimmed or switched on and off. The dimmer
switch function is activated or deactivated using the function selection switch 8.
● The function selection switch 8 is set to the ON position as standard. This ac-
tivates the dimmer function.
● If you wish to deactivate the dimmer switch for the additional output, place
the function selection switch 8 in the OFF position.
p. 26/40