BORETTI CFBI 601 AN Mode D'emploi page 224

Grease filter (some models only)
* A special screen is provided at the
back of the oven to catch grease
particles, mainly when meat is
being roasted (fig. 6.5).
* Clean the filter after any cooking!
The grease filter can be removed
for cleaning and should be
washed regularly in hot soapy
water (fig. 6.5).
* Always dry the filter properly
before fitting it back into the oven.
Caution
When baking pastry etc. this filter should be removed.
Telescopic sliding shelf supports (some models only)
The telescopic sliding shelf supports
make it safer and easier to insert and
remove the oven shelves and trays.
They stop when they are pulled out
to the maximum position.
Important! When fitting the sliding
shelf supports, make sure that
you fit:
* The slides to the top wire of a rack.
They do not fit on the lower wire.
* The slides so that they run out
towards the oven door.
* Both sides of each pair of shelf
slides.
* Both sides on the same level.
To fix the sliding shelf supports onto
the side racks:
* Screw the side racks onto the oven wall (fig. 6.1).
* Fit the sliding shelf supports onto the top wire of a rack and press (fig. 6.6).
You will hear a click as the safety locks clip over the wire.
Left
224
Fig. 6.5
Fig. 6.6
Right