Electrical Section - BORETTI CFBI 601 AN Mode D'emploi

2 Electrical section

Important
The cooker must be installed in accordance with the manufacturer's
instructions. Incorrect installation, for which the manufacturer accepts
no responsibility, may cause damage to persons, animals and things.
General
* Connection to the mains must be carried out by qualified personnel in
accordance with current regulations.
* The appliance must be connected to the mains checking that the voltage
corresponds to the value given in the rating plate and that the electrical
cable sections can withstand the load specified on the plate.
* The cooker can be connected directly to the mains placing an omnipolar
switch with minimum opening between the contacts of 3 mm between the
appliance and the mains.
* The power supply cable must not touch any hot parts and must be
positioned so that it does not exceed 75°C at any point.
* Once the cooker has been installed, the switch must always be accessible.
* If the power supply cable is damaged it must be substituted by a suitable
cable.
N.B.
For connection to the mains, do not use adapters, reducers or
branching devices as they can cause overheating and burning.
If the installation requires alterations to the domestic electrical system,
call an expert. He should also check that the domestic electrical system
is suitable for the power absorbed by the appliance.
Before effecting any intervention on the electrical parts of the appliance,
the connection to the network must be interrupted.
The connection of the appliance to earth is mandatory.
The manufacturer declines all responsibility for any inconvenience
resulting from the inobservance of this condition.
190