Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Anti-tilt bracket
Warning
This appliance must be restrained to prevent accidental tipping by
fitting a bracket to the rear of the appliance and securely fixing it to the
wall.
To fit the anti-tilt bracket:
1. After you have located where the cooker is to be positioned, mark on the
wall the place where the 2 screws of the anti-tilt bracket have to be fitted.
Please follow the indications given in fig. 1.8.
2. Drill two 8 mm diameter holes in the wall and insert the plastic plugs
supplied.
Important!
Before drilling the holes, check that you will not damage any pipes or
electrical wires.
3. Loosely attach the anti-tilt bracket with the 2 screws supplied.
4. Move the cooker to the wall and adjust the height of the anti-tilt bracket
so that it can engage in the slot on the cooker's back, as shown in fig. 1.8.
Fig. 1.8
188
Publicité
Table des Matières
