BORETTI CFBI 601 AN Mode D'emploi page 198

Important note
The cooking zones will not operate if the pan/coffee pot diameter is too
small. To correctly use the cooking zones follow the indications given in
the following table.
Induction cooking zone
Cooking zone Ø 145 mm
Cooking zone Ø 210 mm
Important
Some cookware available on the market is not of good quality or has an
effective ferromagnetic area which is much smaller than the diameter
of the pan itself. Avoid using this cookware because the induction
cooktop may not function properly or may be damaged.
Pay attention
The pan/coffee pot shall always be centred over the middle of the
cooking zone.
Pay attention
If using a grill pan do not select the maximum level for a too long time,
the pan may become deformed due to the excessive heat. Always use
pans with thick bottom.
It is possible to use oversized pans/coffee pots but its bottom shall not
touch the other cooking zone.
Always use pans/coffee pots with thick, completely flat bottom.
Do not use pans/coffee pots with concave or convex bottom; these could
cause overheating of the cooking zone.
Note
Some types of pans/coffee pots could cause noise when used on an
induction cooking zone.
The noise does not mean any failure on the appliance and does not
influence the cooking operation.
Minimum pan diameter recommended
(referred to the bottom of the pan/coffee pot)
90 mm
130 mm
198