Replacing The Battery; Thermostat - External Chronothermostat; Idle Period (End Of Season); Stove Cleaning - Anselmo Cola TERMOPLUS 23 Manuel D'installation, D'utilisation Et D'entretien

4.7.1 Replacing the battery

The remote control is powered by a 3-volt CR2025 type battery located in the bottom of the device. For its insertion
and possible replacement, proceed as follows:
- operate the lever indicated;
- pull out the battery tray completely and replace the battery (3-volt CR2025 model)
respecting the polarity;
- insert the tray;
- check proper operation with the unit running.
- Keep the remote control away from direct heat sources and water.
- The batteries of the remote control must be replaced and disposed of separately
in special containers in a safe way in accordance with local environmental regulations.

4.8 Thermostat - external chronothermostat

To use an external thermostat, contact an authorised technician and proceed as follows:
- turn off the power by means of the main switch on the back and detach the power
cable;
- remove the side panel to access the electronic controller;
- referring to the wiring diagram, connect the two wires of thermostat to the respective
board TERM terminals;
- refit everything and check correct operation.
The setting procedure is as follows:
- external thermostat: SET in the menu M-6-7 in T-AMBIEN;
- external chronothermostat: SET in the menu M-6-7 in T-AMBIEN and disable the
All the menu functions do not change for each of the settings and signalling of the
connection occurs with lighting up of the segment LED on the status bar of the display.

4.9 Idle period (end of season)

If the stove is not used for long periods, or at the end of each season, it is advisable to proceed as follows:
- remove all the pellets from the hopper;
- disconnect the power supply;
- clean thoroughly and, if necessary, have any damaged parts replaced by qualified personnel;
- protect the stove from dust with suitable covering;
- store in a dry and safe place protected from atmospheric agents.

5 STOVE CLEANING

Stove cleaning is very important to prevent: blackening of the glass, poor combustion, deposits of ash and unburnt
products in the brazier, reduced thermal efficiency.
The stove must only operate with the fire door closed.
The fire door seals must be checked periodically to prevent any air from entering; the combustion chamber and pellet
duct work in a negative pressure and the fume exhaust in a positive pressure.
Routine cleaning is normally carried out by the customer following the instructions in the manual, whereas
extraordinary maintenance, at least once a year, must be performed by the authorised Service Centre.
Cleaning operations for all parts must be carried out with the stove unplugged and cold;
Dispose of cleaning waste in accordance with the current local regulations;
The stove must not be operated without its cladding;
Avoid the creation of smoke and unburnt products during lighting and/or normal operation.
chrono functions from the menu 01-01.
battery tray
lever
50 TERMOPLUS 23