Adjusting The End Stops - RADEMACHER RolloTube Small Série Traduction Du Mode D'emploi Original

Adjusting the end stops

1.
2.
3.
*
DE ES FR EN NL
NOTE
Perform a test run on the motor first, without the roller shutter curtain in place.
Let the motor run (using a time switch or a switch) in the down ( ) direction until it
shuts off by itself. Please ensure that this is the correct downward direction, or down
( ), for your roller blind.
If the roller blind motor is running in the wrong direction (motor running direction does not
match the switch positions for up ( ) and down ( )), switch the brown and black conductors
in the junction box or switch box.
◆ Now run the motor further in the down ( ) direction until it reaches the lower limit stop.
Assembly of the roller shutter curtain (figure
Install the roller shutter curtain (17) on the winding shaft (5) using ties (6) (accessories).
Never drill or screw into the area of
the drive to mount the roller blind.
IMPORTANT
The limit stops work only if the motor is
installed in the winding shaft.
Slide the tie (6) onto the topmost segment of the roller shutter curtain (17).
a)
Place an tie (6) in the rectangular holes in the winding shaft (5) every 40 cm.
b)
For SW 40 winding shafts (with outer seams), use hanging brackets (20) to assem-
c)
ble the tie (6); see Figure
IMPORTANT
The end stops for the top and bottom are adjusted by means of 2 adjustment screws. Use
the included adjustment tool to turn the screws.
End stop adjustment
adjustment screws
Bei Rechts-/ oder Linkseinbau: Mit der Einstellschraube am nach oben zeigenden Pfeil wird der unt
◆ For right or left-hand installation: The lower end stop is set using the adjustment screw
Endpunkt eingestellt. Mit der Einstellschraube am nach unten zeigenden Pfeil wird der obere Endp
on the arrow pointing upwards. The upper end stop is set using the adjustment screw
on the arrow pointing downwards.
◆ Turning in the + (plus) direction extends the route.
◆ Turning the opposite way causes it to shorten.
* The actual plus and minus directions may vary by model.
Check the printing on the motor head.
/ )
.
= down
adjustment tool
= up
EN
= extension
of each route
= shortening
each route
53