Installing The Tubular Motor; Installing The Bearings; Determine The Length Of The Winding Shaft; Assembly / Disassembly Of Adapters And Driver - RADEMACHER RolloTube Small Série Traduction Du Mode D'emploi Original

Installing the tubular motor

NOTE
The following installation instruction apply to standard
installation situations for RADEMACHER tubular motors
and accessories.
The drive head (12) of the motor can be installed on the
right or left side of the roller blind box. Installation on the
right side is shown in these instructions.
Installing the bearings (Figure
First, determine the position of the drive (13) and counter
1.
bearings (1) in the roller shutter curtain.
Wind the roller blind shield completely onto the winding
shaft, and measure the diameter D. See Figure
determining the position of the centre of the bearing on
the guide track.
IMPORTANT
When installed, the wound-up roller blind must run verti-
cally in the guide track on the window.
Determine the length of the winding shaft (Figure
Measure the distance from the drive (13) to the counter
1.
bearing (1), as shown.
Assembly / disassembly of adapters and driver (Figure
Assembling the adapter (10)
1.
Slide the adapter (10) over the limit ring (18) on the
drive head until it engages. Make sure the groove in
the adapter (10) is correctly positioned.
Disassembling the adapter (10)
2.
Press down on both retaining springs on the limit ring
(18) and pull the adapter (10) off of the limit ring (18).
DE ES FR EN NL
)
2.
for
)
2.
3.
1.
2.
Mount the bearing, depending on the type of bearing
and the building situation.
Assemble the drive bearing (13) such that the adjustment
screws (11) will be accessible later, and the motor cable
can be run without kinking.
Take care that the bearings are level when installed.
A roller blind that is crooked when wound up can jam
and destroy the drive.
Measure the roller blind box and determine the shaft
length (L) needed.
Length of the winding shaft:
Cut off the winding shaft (5) to the required dimension.
Saw off the shaft squarely with a metal saw to the correct
dimension. Deburr the shaft, inside and outside, with a file.
B = Counter bearing / Roller capsule
C = Drive bearing / Motor
)
Assembling the driver (8)
Slide the driver (8) onto the axle (19) to the stop and
secure it with the included securing clip (7).
Disassembling the driver (8)
Remove the securing clip (7) from the axle (19) and
disassemble the driver (8).
EN
L = A - (B + C)
49