NOMICS BRIZZY NS21 Manuel D'utilisation page 31

Sensors operation:
PULSE OXIMETER
The Xpod module from Nonin measures the blood oxygen saturation level
(SpO2) and the pulse frequency of the patient. Only Nonin-branded oximetry
sensors should be connected to the Xpod module.
ELECTROCARDIOGRAM - ECG 1 way
The ECG module allows to measure, by three electrodes, the patient's cardiac
cycle and heart rate.
Operating mode with option ECG:
Start-up
Connection of white connector (ECG) alone.
Connection of white connector (ECG) and
black (Jawac).
For a "24h" ECG recording:
• Connect the ECG module to the device (white connector). In this particular recording mode,
only a portion of the ECG data will be recorded.
• Before falling asleep, connect the distance sensor to the device (black connector). The
recorder will switch to normal recording mode.
• At wake-up, disconnect only the distance sensor (black connector). The recorder then contin-
ues the partial recording of ECG signals.
Battery autonomy:
The battery must be recharged after each recording.
When the device is used WITH oximetry module:
If the battery is charged, its autonomy is sufficient to ensure a full night's recording.
When the device is used WITH ECG module:
If the battery is charged, its autonomy is sufficient to ensure 24 hours of monitoring and
recording.
© Nomics s.a. All rights reserved
Operating mode
Partial recording of ECG data.
Complete recording of all the data.
MU_BRIZZY_REV5 / 03-2017 Eng-29
Eng