Installing The Recorder - NOMICS BRIZZY NS21 Manuel D'utilisation

INSTALLING THE RECORDER

The illustration shown at the beginning of this guide gives a general picture of the installation of
the device and the sensor.
The fastening belt slides into the slots of the device and serves to maintain the device at waist
level. To prevent any skin irritation, it should be placed over a T-shirt or pajama top.
In order to record the correct position, the device must be well maintained and positioned at the
front, at waist level. The front panel of the device must be visible with connectors on the top.
The ends of the belt have Velcro fastenings so that it can easily be adjusted. It must fit the body
closely but should not be too tight. The patient must be able to breathe freely.
Installation of the mandibular movement sensor
Placement of the sensor on the patient's face is illustrated in the operating instructions included
with the sensor and in the patient's leaflet. A simple reminder here is that it is important that
the probes are parallel and on the same vertical axis. To install the probe on the patient's face,
use only hypoallergenic adhesive tape in order to avoid any risk of allergic reaction.
The sensor for measurement of mandibular movement is reusable but must be properly
cleaned between each use (see operating instructions of sensor).
Connection
© Nomics s.a. All rights reserved
Indications on the device must be observed when connecting the
sensors. The mandibular movement sensor plugs into the socket
marked 'JAWAC'. The optional oximetry module from Nonin, or the
ECG module, plugs into the 'AUX' entry.
Each connector has a notch, which matches a bump on the corre-
sponding socket on the device. Once notch and bump are aligned,
push the connector in until locked in place.
MU_BRIZZY_REV5 / 03-2017 Eng-13
Eng