Table des Matières
Publicité
Installation (Seuls les installateurs qualifiés)
Installation du panneau
PANEL SIZE
8" x 10" Rectangular
Arched (8" x 10")
10" x 13" Rectangular
4" x 6" Rectangular
L'insertion peut être installée sans panneaux surround.
NOTE:
L'insertion peut être
NOTE:
installée sans panneaux
surround.
1
Suivez les indications vers la
droite pour installer les panneaux
latéraux.
2
Suivez les instructions ci-
dessous pour installer le
panneau supérieur.
a
Install the top panel so
the tabs insert into the
joggle clips on the top
panel
© Travis Industries
WIDTH
HEIGHT
1026mm
743mm
1026mm
743mm
1127mm
810mm
943mm
635mm
b
Line up each side surround
panel and insert two screws from
the inside to secure in place.
Top Trim
Top
Spring
Panel
Clips
4101216
PART #
96100301
98500605
96100302
96100300
b
Top Trim
"L" Bracket
Right Side
Trim
"L" Bracket
Trim Installation:
Insert one leg of each "L" bracket into the top
and side trim piece. Align the trim to form a
precise corner, then tighten the two set
screws with a small standard screwdriver.
Right Side Trim
Slide the trim over the panels. Place the
spring clips behind the panels at the locations
shown. This keeps the trim tight against the
panel.
Optional Knock-Out
An optional knock-out is provided if the power cord is
routed behind the surround panel.
Pre-thread the holes on the surround
a
panels with the screws included in the
surround panel kit.
5/16" Nutdriver
Run the power cord to
the right of the insert.
Micro (1/16")
Standard
Screwdriver
100-01235FR
19
Publicité
Table des Matières
