Table des Matières
Publicité
Installation (for qualified installers only)
Installation du panneau Surround
REMARQUE: L'insert peut être installé sans panneaux surround.
3-Piece Surround Panneaux
TAILLE DE L'ÉCRAN
8" x 10" Rectangulaire
Arqué (8" x 10")
10" x 13" Rectangulaire
4" x 6" Rectangulaire
1
Suivez les indications pour le
droit d'installer les panneaux
latéraux.
2
Suivez les instructions ci-
dessous pour installer le
panneau supérieur.
Top
Panel
a
Install the top panel so
the tabs insert into the
joggle clips on the top
panel
© Travis Industries
LARGEUR
40-3/8"
40-3/8"
44-3/8"
37-1/8"
b
Line up each side surround
panel and insert two screws from
the inside to secure in place.
Top Trim
Spring
Clips
"L" Bracket
Right Side Trim
1/25/2019 – 1285-FR
HAUTEUR
PARTIE #
28-7/8"
96100301
28-7/8"
98500605
31-7/8"
96100302
25"
96100300
Micro (1/16")
Standard
Screwdriver
b
Top Trim
"L" Bracket
Right Side
Trim
Trim Installation:
Insert one leg of each "L" bracket into the top
and side trim piece. Align the trim to form a
precise corner, then tighten the two set
screws with a small standard screwdriver.
Slide the trim over the panels. Place the
spring clips behind the panels at the locations
shown. This keeps the trim tight against the
panel.
Optional Knock-Out
An optional knock-out is provided if the power cord is
routed behind the surround panel.
Pre-thread the holes on the surround
a
panels with the screws included in the
surround panel kit.
5/16" Nutdriver
Run the power cord to
the right of the insert.
COUVERTURE POUR
BOUGIES DE MARCHE
/ ARRÊT ET
RHEOSTAT
Je nstallez la fiche et
branchez le bouton
interrupteur sur le
panneau de garniture
Surround pour cacher
les trous de montage
(voir l'illustration ci-
dessous).
DVS GSR2
21
Publicité
Table des Matières
