Sulky XEOS PRO Notice Originale page 29

Mise en route /Start-up / Inbetriebsetzung
G
Tractor control
- To be checked :
• The total authorised weight.
• The permitted weight per axle.
• The authorised support weight on the tractor's linkage.
• The permissible load capacity for the tyres fitted to the tractor.
• Is the authorised linkage weight sufficient?
All of this information can be found on the registration papers, or on the data plate and in the tractor manual.
Figures that you should know
P Kg
P1 Kg
Weight on the front axle when the tractor is empty
P2 Kg
Weight on the rear axle when the tractor is empty
m1 Kg
m2 Kg
Weight of the rotary harrow or of the tool
m3 Kg
Distance between the centre of gravity of the front
m
a
ballast and the centre of the front axle
m
b
Distance between the lower linkage pins and the
m
c
Distance between the lower linkage pins and the
m
d
centre of gravity of the machine.
Distance of the centre of gravity from the rotary
2 m
d
3 m
Distance of the centre of gravity of drill + seed
d
M1 mini = Calculation of the minimum ballast need in front.
Pc = Calculation of the total weight of the unit (tractor + machine)
v
alueS calculated
P1
c
P2
c
P
c
- Complete the table below:
- Check that:
• The values calculated should be
• It is essential that the minimum load on the front axle is > or = to 20% of the unladen tractor weight.
The machine must not be hitched to a tractor if :
The total weight calculated is > than the maximum authorised weight.
The weight on the front axle is ‹ than the minimum required.
Unladen weight of tractor
Total weight of front ballast
Weight of the drill + seed
Wheelbase of tractor
centre of the rear axle.
harrow
‹
or = to the tractor's permissible values and the values for the tyres fitted to the tractor.
Consult the tractor's instruction manual or the registration
Consult the technical characteristics of the tractor and the
front ballast, or measure.
Consult the technical characteristics of the rotary harrow or
Consult the machine's technical characteristics. (see section
Consult the technical characteristics of the tractor and the
front ballast, or measure.
Consult the instruction manual or the tractor's registration
documents, or measure.
Consult the machine's technical characteristics. (see section
P1c = Calculation of the weight on the front axle
P2c = Calculation of the weight on the rear axle
t '
ractor S
PermiSSible valueS
documents.
of the tool
"Characteristics").
"Characteristics").
v
alueS PermiSSible with
the tyreS that are
Fitted to the tractor
2
EN
29