Maintenance - Burkert 8020 Manuel D'utilisation

Pulse input on external instrument
- +
- +
Power supply
12-36 V DC
Fig. 6: PNP wiring of the Hall version
3
2
1
4
Fig. 7: Pin assignment of the fixed connector, Hall Low
Power version
English
32
Terminal block of the 2508
- +
IN = pulse input on remote transmitter
IN
Remote transmitter
Fig. 10: Wiring of the sinus output of a sinus version
English
34
1
V+
3
2
0 V DC
1 : V+ (12-36 V DC)
2 : NPN transistor output
3 : 0 V DC
4 : Not connected
1
3
2
Terminal block of the 2508
- +
IN
IN = pulse input on remote transmitter
Remote transmitter
Fig. 8: NPN wiring of the Hall Low Power version
3
2
1
4
Fig. 9: Pin assignment of the fixed connector, sinus
version
8.

mAinTenAnce

safety instructions
danger
risk of injury due to electrical voltage.
• Shut down and isolate the electrical power source
before carrying out work on the system.
• Observe all applicable accident protection and safety
regulations for electrical equipment.
risk of injury due to high pressure in the installation.
• Stop the circulation of fluid, cut off the pressure
and drain the pipe before loosening the process
connections.
risk of injury due to high fluid temperatures.
• Use safety gloves to handle the device.
• Stop the circulation of fluid, and drain the pipe before
loosening the process connections.
• Keep all easily flammable material and fluid away from
the device.
1
3
2
1 : Not connected
2 : Sinus output
3 : Sinus output
4 : Not connected
English
English
33 33
35 35