Use - Cleanmaxx VC-S1001 Mode D'emploi

use

CAuTIOn!
❐ The openings on the device must not be blocked to ensure that the motor does not
overheat or suffer damage.
❐ Hold the hand-held vacuum cleaner securely when you are using it so that it does not fall
out of your hand.
❐ Never hold the nozzles, in particular the turbo nozzle with its rotating brush, close to
parts of your body or animals during use and do not place your hands inside the noz-
zles. They could become stuck to the device/injured. Should the vacuum cleaner become
stuck, switch the device off immediately (move On/Off switch to position 0). Keep the
turbo nozzle away from objects which could become caught in the rotating brush.
❐ Switch on the vacuum cleaner only when you have checked that all the parts have been
properly attached and that the dust container and the filter are correctly inserted.
❐ Always switch the device off first and pull the mains plug from the mains socket before
you replace the nozzles and any other accessories!
❐ On no account should the device be used to suck up the following:
– Liquids or wet substances (e. g. wet carpet shampoo)
– Glowing ash, cigarette ends, matches, etc.
– Inflammable or explosive substances
– Very fine dust (e. g. concrete dust), ash or toner
– Pointed, hard objects such as e. g. large pieces of broken glass
1. Depending on whether you wish to use the vacuum cleaner as a hand-held or floor
vacuum cleaner, insert the telescoping rod (13) if necessary or detach it.
2. Insert the nozzle you want into the suction opening (6) and attach the suction hose (17).
If necessary, attach the carrying strap (16) to the device.
3. Unwind the mains cable to its full length and insert the mains plug into a properly in-
stalled mains socket that is easily accessible.
01328_9_DE-GB-FR-NL_V0.indb 21
4. If you are using the suction hose and carrying strap, hang it
over your shoulder.
5. Move the On/Off switch (10) to position 1 to switch on the
vacuum cleaner.
6. Guide the nozzle over the surface to be cleaned.
7. After you have finished vacuuming, move the On/Off switch
to 0 and remove the mains plug.
8. To ensure optimum performance of the device, you should
empty the dust container (8) and clean the filter (5) after
every use (see next chapter).
21
07.09.11 12:28