Vision Fitness TF40 Manuel Du Propriétaire page 21

ASSEMBLY STEP 5
HARDWARE FOR STEP 5 :
FLAT
WASHER (H)
8 mm
Qty: 4
BOLT (I)
FLAT WASHERS (H)
CONSOLE REAR COVER
PRE-INSTALLED
SCREWS
CONSOLE CABLES
FLAT WASHERS (H)
SPRING WASHER (J)
NUT (K)
T40 ONLY:
SPRING
BOLT (I)
NUT (K)
WASHER (J)
45 mm
Qty: 2
8 mm
Qty: 2
Qty: 2
CONSOLE
CONSOLE BASE
SUPPORT BAR
SUPPORT BAR CAP
Open HARDWARE FOR STEP 5.
A
Remove 2 PRE-INSTALLED SCREWS to
B
remove CONSOLE REAR COVER from the
CONSOLE.
Attach the CONSOLE to the CONSOLE BASE
C
using 2 BOLTS (I) and 2 FLAT WASHERS
(H) from above and 2 FLAT WASHERS (H) 2
SPRING WASHERS (J) and 2 NUTS (K) from
below.
NOTE: Be careful not to pinch the console
cables while attaching the console.
Connect the CONSOLE CABLES to the
D
CONSOLE.
Re-attach the CONSOLE REAR COVER to
E
the CONSOLE using 2 PRE-INSTALLED
SCREWS.
T40 ONLY: Insert SUPPORT BAR CAPS into
F
bottom of SUPPORT BARS.
ALL
MODELS
21