Vision Fitness TF40 Manuel Du Propriétaire page 11

T40 ASSEMBLY STEP 1
T40 HARDWARE FOR STEP 1 :
BOLT (A) SPRING WASHER (B)
20 mm 8.2 mm
Qty: 6 Qty: 6
T40 ONLY
RIGHT CONSOLE MAST
LEFT CONSOLE MAST
BOLTS (A)
SPRING WASHERS (B)
ARC WASHERS (C)
BASE FRAME
NOTE: This step is for T40 models only.
A Open HARDWARE FOR STEP 1.
ARC WASHER (C)
8.4 mm
B Attach LEAD WIRE to CONSOLE CABLE and pull
Qty: 6
LEAD WIRE through RIGHT CONSOLE MAST. After
pulling the LEAD WIRE through the mast, the top of
the CONSOLE CABLE should be located at the top
of the mast. Detach and discard LEAD WIRE.
NOTE: Do not pinch console cable when placing
N
the mast onto the base frame.
C Attach CONSOLE MAST to BASE FRAME using 3
BOLTS (A), 3 SPRING WASHERS (B) and 3 ARC
LEAD WIRE
WASHERS (C).
CONSOLE CABLE
NOTE: Do not tighten bolts until step 4 is complete.
D Repeat step C on other side.
T40
ONLY
11