Vision Fitness TF40 Manuel Du Propriétaire page 12

TF40 ASSEMBLY STEP 1
TF40
BOLT (A)
20 mm
ONLY
Qty: 6
TF40 ONLY
RIGHT CONSOLE MAST
LEFT CONSOLE MAST
SCREW (M)
BASE FRAME COVER
BOLTS (A)
SPRING WASHERS (B)
ARC WASHERS (C)
BASE FRAME
12
TF40 HARDWARE FOR STEP 1 :
SPRING ARC
WASHER (B) WASHER (C)
8.2 mm 8.4 mm
Qty: 6 Qty: 6
LEAD WIRE
CONSOLE CABLE
SCREWS (N)
NOTE: This step is for TF40 models only.
A Open HARDWARE FOR STEP 1.
SCREW (M) SCREW (N)
20 mm 12 mm
Qty: 2 Qty: 4
B Slide BASE FRAME COVERS over BASE FRAME.
Attach BASE FRAME COVERS using 2 SCREWS
(M) and 4 SCREWS (N).
C Attach LEAD WIRE to CONSOLE CABLE and pull
LEAD WIRE through RIGHT CONSOLE MAST. After
pulling the LEAD WIRE through the mast, the top of
the CONSOLE CABLE should be located at the top
of the mast. Detach and discard LEAD WIRE.
NOTE: Do not pinch console cable when placing
the mast onto the base frame.
D Attach CONSOLE MAST to BASE FRAME using 3
BOLTS (A), 3 SPRING WASHERS (B) and 3 ARC
WASHERS (C).
NOTE: Do not tighten bolts until step 4 is complete.
E Repeat step C on other side.