Vision Fitness TF40 Manuel Du Propriétaire page 13

TF20 ASSEMBLY STEP 1
TF20 HARDWARE FOR STEP 1 :
BOLT (A)
20 mm
Qty: 6
TF20 ONLY
RIGHT CONSOLE MAST
LEFT CONSOLE MAST
BASE FRAME COVER
BOLTS (A)
SPRING WASHERS (B)
ARC WASHERS (C)
BASE FRAME
SPRING ARC
WASHER (B) WASHER (C)
8.2 mm 8.4 mm
Qty: 6 Qty: 6
LEAD WIRE
CONSOLE CABLE
NOTE: This step is for TF20 models only.
A Open HARDWARE FOR STEP 1.
B Slide BASE FRAME COVER up RIGHT CONSOLE
MAST. Attach LEAD WIRE to CONSOLE CABLE
and pull LEAD WIRE through RIGHT CONSOLE
MAST. After pulling the LEAD WIRE through the
mast, the top of the CONSOLE CABLE should be
located at the top of the mast. Detach and discard
LEAD WIRE.
NOTE: Do not pinch console cable when placing the
mast onto the base frame.
C Place RIGHT CONSOLE MAST over BASE FRAME.
D Attach CONSOLE MAST to MAIN FRAME
BRACKET using 3 BOLTS (A), 3 SPRING
WASHERS (B) and 3 ARC WASHERS (C).
NOTE: Do not tighten bolts until step 4 is complete.
E Slide BASE FRAME COVER up LEFT CONSOLE
MAST. Repeat STEP D to attach LEFT CONSOLE
MAST.
F Slide BASE FRAME COVERS down.
TF20
ONLY
13