KERN YDB-03 Mode D'emploi page 99

5. Put solid material into the lower sifting bowl.
For this remove the immersion basket out from the frame. Always ensure that,
when re-immersing into the liquid, no additional bubbles adhere; it is better to use
pincers or alike to place the sample directly on the sifting bowl. Make sure that the
sample is at least 1 cm immersed.
6. Press the UNIT button. "WAIT" is displayed. The weighing scale first determines,
then displays the solid matter's density.
7. If you connect an optional printer you can print the result.
8. Remove the sample. To carry out further measuring, press UNIT, and then start
with step 2.
To avoid corrosion, don't leave the density set immersed in liquid for a long time.
YDB-03-BA-e-1410
Figure 2: Weighing in auxiliary liquid
21