Series Kern Alt_B - KERN YDB-03 Mode D'emploi

6.5 Series KERN ALT_B

 In weighing mode press MENU button. The master menu will be displayed.
 Use the navigation buttons  to select the menu item „Density".
 Acknowledge using PRINT button, the current setting is displayed.
 Use the navigation buttons  to select the setting „Liquid".
 Confirm using the PRINT button, the currently set density of the sinker is
displayed (factory setting 3.0000 g/cm
 For any change press the TARE key.
Use the navigation buttons  to increase/reduce the digit. Use the TARE button
to select the next digit. Repeat this sequence for each digit. To delete keep
pressed the TARE button.
 Confirm entry with PRINT button, the display for calculation of „Weight in air" is
displayed.
Should the balance not show Zero, press the TARE button.
 Place sinker in the upper sample dish, see fig. 5, chap. 6.1.2.
 Wait for stability display [ ], then take over the weight value using the PRINT
button.
64
3
).


YDB-03-BA-e-1410