Preparation; Assembly - Aprimatic T4Power Instructions Pour L'installation

2.1 PREPARATION

Before installing the device, prepare the tools required for securing it to the wall and to
make the electrical connections. The following are also required:
1. expansion wall plugs dia. 6 mm
2. Skintop type PG16 cable clamps
3. a multipole switch with a minimum contact opening of 3 mm for mains power supply
4. an emergency pushbutton
5. approved cables for external use with minimum cross-section of 0.75 and 1.5 mm²

2.2 ASSEMBLY

It is not necessary to drill any holes inside the plastic container to fit the device.
1. Secure the device at a minimum height of 30 cm, using the securing holes on the 4
corners of the plastic container.
2. Insert the connecting cables, through the holes in the bottom of the container and
the cable clamps indicated.
3. Fit a multipole switch for the power supply upstream of the device.
4. Fit an emergency pushbutton in a position where the automation system can be
seen and so that the power supply to the system can be completely cut-off.
5. Use 1.5 mm² section cables for the motor power supply and 0.75 mm² section
cables for 24 VDC devices.
Note - The safety contacts (terminals 2-4 stop input, 2-3 photocell input, 2-6 internal
or additional photocell input) if not used, must be jumpered by the installer.
ENGLISH
Motor 2 (24 VDC)
Motor opening delay 1.5 sec.
Motor 1 (24 VDC)
Enabled for closing delay (TR1)
To the battery-charger circuit (C.B.)
20
0
green
20
N
Primary transformer
230 VAC
PH
N
230 VAC
PH
Electric lock
24 VDC flashing LED
24 VDC accessory output
Pedestrian opening push-button (Start 2) N.O.
Internal photocell contact
24 V warning light (max 3 W)
Common (-)
N.C. photocell contact
N.C. Stop push-button
N.O. Start push-button
green
yellow
T4pow-MO.EPS
5