Preparation; Assembly; Electrical Connections - Aprimatic A80M-2 Professional Instructions Pour L'installation

CAUTION - The product must only be installed by qualified servicing and/or
installation personnel.
CAUTION - The electrical system must comply with the current regulations in the
country where the product is installed.

2.1 PREPARATION

Before installing the device, prepare the tools required for securing it to the wall
and to make the electrical connections. The following are also required:
1. expansion wall plugs dia. 6 mm
2. Skintop type PG16 cable clamps
3. a multipole switch with a minimum contact opening of 3 mm
4. an emergency pushbutton
5. approved cables for external use with minimum cross-section of 0.75 and
1.5 mm²

2.2 ASSEMBLY

It is not necessary to drill any holes to fit the device.
1. Secure the device at a minimum height of 30 cm, using the securing holes in
the plastic container.
2. Insert the connecting cables, through the holes in the bottom of the container
and the cable clamps indicated.
3. Fit a multipole switch upstream of the device.
4. Fit an emergency pushbutton in a position where the automation system can
be seen and so that the power supply to the system can be completely cut-off.
5. Use 1.5 mm² section cables for the motor power supply and 0.75 mm² section
cables for 24 VDC devices.

2.3 ELECTRICAL CONNECTIONS

WARNING- Make sure that the mains power supply is turned OFF before making
the connections.
CAUTION - Do not use intercom or telephone cables.
Make the electrical connections as indicated in the diagram alongside.
LIMIT SWITCH
N.B. Fit a jumper on the normally closed contacts (2 and 3, 7 and 8), if they are
not used.
Pilot light
max 24 VDC 5 W
Photocell
max 150 mA
Closing safety
devices
Normally closed contacts (the various
contacts must be connected in series)
Radio receiver
max 100 mA
STOP pushbutton
Normally closed
START pushbutton
Normally open
APR01002.EPS