Description; Block Diagram Of The Device; Installation - Aprimatic T4Power Instructions Pour L'installation

1. DESCRIPTION

Device fitted with Aprimatic microprocessor designed to drive 2 motors with a maximum
power of 380 Watt. Stand-by consumption 15 Watt.

1.1 BLOCK DIAGRAM OF THE DEVICE

TR1 Pause time trimmer
TR2 Gate closing delay trimmer
TR3 Thrust force adjustment trimmer
Note - Turn clockwise to decrease sensitivity and increase thrust force.
JP Set of jumpers
JP1 Semiautomatic mode
JP2 Reverse stroke disabled
JP3 Pre-flashing disabled
JP4
JP5 2 motors (2 wings)
Note - The wing opening delay is fixed at 1.5 seconds.
CN1 Plug-in Aprimatic radio receiver terminal board
CN2 Input terminal board
CN3 Power supply and transformer terminal board
CN4 Accessories terminal board
FS1-FS9 Faston plug connectors
C.B. Terminal for battery-charger circuit connection
M1 Terminal for motor connection 1 (wing 1)
M2 Terminal for motor connection 2 (wing 2)

2. INSTALLATION

CAUTION - The product must only be installed by qualified servicing and/or installation
personnel.
CAUTION - The electrical system must comply with current regulations in the country
where the product is installed.
CAUTION - Always make sure that the mains power supply is turned OFF before
opening the container. Ensure that there is a good earthing system. Always
connect it to the relative terminals.
Automatic
Enabled
Enabled
Recessed motors
1 motor (1 wing)
T4-power.EPS