Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.2
Wall installation - Double-sided clock
2.2.1 Mechanical installation
Caution: the double-sided version of this clock model can weigh up to 29 kg. This fact, in
addition to the mechanical stress involved, means that we recommend a concrete wall as
the preferred installation for this double-sided clock.
- Unscrew and remove the air inlet screw
beneath the bracket arm (Allen key 6),
- Partially unscrew the four cover screws
on one clock face,
- Carefully slide open and partially separate this clock face
to access the clock's internal cabling,
- Disconnect the cable connected to the movement on both
clock faces,
- Remove the first clock face completely and place it onto a
clean, clear and level work surface,
- Partially unscrew the four cover screws
clock face, then remove this clock face and place it onto a
clean, clear and level work surface.
- Remove the cardboard wedge between the movement and the dial.
At the site of installation:
- Drill four holes following the layout and dimensions shown above,
- Feed the cable through the clock's bracket arm,
- Place the clock bracket in position and tighten the wall fixings,
It is recommended that you apply a silicone seal between the backing plate and the wall for
watertightness,
- Reposition the clock face opposite the grommet having first cleaned the clock face seal and
then having applied silicone oil on it,
- Tighten the four cover screws
- Reconnect the cable to the movement on this clock face (limit its length with the cable clip),
- Before repositioning the clock face on the grommet side, follow the instructions to complete the
electrical installation.
If subsequent maintenance is required, remove only the clock face on the grommet side.
However, access to the battery (optional) requires removal of the side opposite to the grommet.
Cover
screw
Torque: 1.2 Nm
Movement
connector
Cable clip
1
located
2
(Allen key 3)
2
on the second
2
(1,2 Nm) on this clock face,
2
Air inlet screw
Torque: 15 Nm
15
Grommet
1
EN
70
Ø11
25
Publicité
Table des Matières
