Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. Installation
2.1 Wall installation - Single-sided clock
2.1.1 Mechanical installation
Where the clock is to be installed, drill three holes in the wall according to the following layout and
dimensions pertaining to your model:
For standard mounting on a concrete wall, insert the anchors into the drilled holes.
Note that the clock must be opened before being mounted onto the wall.
To open the clock:
- Unscrew and remove the air inlet screw
(6 mm Allen key),
Air inlet screw
Torque:
15 Nm
- Partially unscrew the four cover screws
on the clock (3 mm Allen key),
- Carefully slide open and partially separate the front face to
access the clock's internal cabling,
- Disconnect the cable connected to the front face movement,
- Remove the front face completely. You are now able to access
the inside of the clock and proceed with wall mounting,
- Place the front face onto a clean, clear and level work
surface,
C
D
1
on the underside of the clock to let air in
1
2
(two each side)
750
760
A
325
410
B
135
170
135
170
C
D
270
340
Cover screws
Torque: 1.2 Nm
Movement
connector
EN
2
21
Publicité
Table des Matières
