Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
II
– Installation
2.1 Clock installation
2.1.1 Mounting without back cover
According to the model of the clock make the cut-out following the dimensions listed in table below:
Style 5S OP
Style 7S OP
Dimensions in mm
a) Insert the clock in the cut-out in order to mark the position of the 4 mounting screws.
b) Remove the clock and drill 4 holes Ø 6mm to insert the wall plugs.
c) Feed the power cable and the synchronisation cable throught the cut-out.
d) Connect the clock, adjust the brightness (refer to page 7) and set the time (refer to page 9).
e) Apply a silicone seal between the clock and the wall.
f) Fix the clock to the wall with the 4 screws Ø4 mm.
A
B
400
46
440
Installation without the back cover
C
D
365
68
404
85
EN
E
107
123
5
Publicité
Table des Matières
