Silk-n Tightra Mode D'emploi page 13

Control Mode
Battery ---
indicator light
(#4)
Both
modes
4.3 Changing modes and energy levels
U
Internal mode: This is the default setting when the device
is first switched on.
U
External mode: To change to the external mode before
you start a treatment, short press the control button (#3)
3 times. You can do this within the first minute that the
device is on.
U
Change modes during use: Once you are using the
device, you will need to shutdown the device, restart it, and
then select the mode you want.
U
Change energy levels during use: To change internal
mode energy levels during a treatment, short press the
control button (#3). Each time you short press, you will
cycle through the 3 internal modes.
4.4 Device charging
Always charge the device before first use. The initial charge
should take approximately 6 hours.
U
Place the USB cable (#8) into the device. Place the other
end of the cable into the USB adapter (#9) and connect to
the electricity supply. The battery and treatment mode
indicator lights (#4, #2) will go on and off, and then the
battery indicator light (#4) will blink green.
U
Recharge the device fully after each 20 minute treatment,
and check the battery level before you start a new
treatment.
Action
Green (blinks)
Green (constant)
Orange (blinks)
Orange
(constant)
11
Explanation
Device charging
Device charged
Low charge in the battery
No charge in the battery
EN