Laying In The Cable Carrier En - Abicor Binzel MasterLiner Maxi Flex Mode D'emploi

6 Putting into operation
1 Wire feeder
Fig. 10 Robot welding cell installation
6.2.2 Laying in the cable carrier
1 Wire feeder
2 Gantry welding system
Fig. 11 Laying in the cable carrier
NOTICE
• When laying the MasterLiner in a cable carrier, note and observe the permissible bending radii.
• Avoid bending the MasterLiner unnecessarily when it is laid. Laying in a cable carrier is essentially
• All liner types are essentially suitable for dynamic movements. For very high dynamic forces and rapid
• For applications involving a longer wire feed distance and/or multiple bends, we strongly recommend
• When suspending liners of any type, use suitable mounts, strain relief devices for the wire feeder and
• The MasterLiner HD and MasterLiner Flex can, in principle, be used in combination. To do so, use
EN - 14
1
1
6
5
4
3
3 Wire drum
4 Welding robot
possible. Breaches of the minimum bending radii can cause damage and wire feed irregularities.
Note the bending radii for use when dynamically laying the MasterLiner:
 3.2 Suspension/total bending angle of all bending radii on page EN-6
robot movements, use the MasterLiner HD version.
using an additional wire drive near the wire drum.
wire drums as well as the wire feed distance.
suitable connectors.
MasterLiner Maxi Flex/HD; Basic Flex/HD
2 Robot welding system
2
5 MasterLiner laying
6 Laying the MasterLiner in a cable carrier
2