Robot Welding Cell En - Abicor Binzel MasterLiner Maxi Flex Mode D'emploi

MasterLiner Maxi Flex/HD; Basic Flex/HD
6.2 Laying
6.2.1 Robot welding cell
Device damage
Device damage as a result of inadequate strain relief on the wire feeder.
• Ensure sufficient strain relief on the wire feeder.
• Connect and lay the MasterLiner without kinks.
Device damage
Device damage as a result of unsuitable suspension devices.
• Only use suitable suspension devices when suspending the liner.
• Do not suspend the liner using cable ties.
Wire feed irregularities
Wire feed irregularities due to the lowest permissible bending radii being breached, too many bending
radii and wire feed distances exceeding 25 m.
• Please note the specifications with regard to the permissible bending angles, bending radii and
• Use an additional drive in the event of wire feed distances of over 25 m.
1 Welding robot
2 Robot welding cell
Fig. 9 Robot welding cell setup
CAUTION
CAUTION
CAUTION
maximum lengths.
 3.2 Suspension/total bending angle of all bending radii on page EN-6
1
6
5
4
3
3 Wire drum 5 Lead-through from MasterLiner protective
4 MasterLiner housing to robot welding system
2
6 Wire feeder
EN - 13