Feeding In The Wire - Abicor Binzel MIG/MAG PP Mode D'emploi

4 Putting into operation
4.6 Setting the shielding gas quantity
NOTICE
• The type and quantity of the shielding gas depends on the welding task and the gas
nozzle geometry.
• Make all shielding gas connections gas-tight.
• To prevent the shielding gas supply from becoming clogged by impurities, the cylinder
valve must be opened briefly before connecting the cylinder. This will expel any impurities
that may be present.

4.7 Feeding in the wire

1
Torch neck
2 Clamping cap
3 Flat-head screw
Fig. 6 Feeding in the wire
NOTICE
• Each time the wire is changed, make sure that the beginning of the wire is free of burrs.
• Make sure that the wire feed roll complies with the diameter of the inserted wire
electrode.
 8.1 Replacing the wire feed roll on page EN-15
1 Insert the wire in the wire feeder as specified by the manufacturer.
2 Remove clamping cap (2) from handle (6).
3 Swing out seat clamp (7) laterally.
4 Press the "Current-less wire feed" trigger at the wire feed unit until the wire emerges from the
contact tip.
5 Lock seat clamp (7) and attach clamping cap (2).
EN - 12
1
7 6
4
Fixing plate
5 Potentiometer (optional)
6 Handle
2
3
4
5
7
Seat clamp
BAL.0212.0 • 2018-07-16
PP