Pentair Intellidrive PID10 Notice D'utilisation page 15

Programming
Table 9 - Continued
Menu
Parameter
Settings
Internal
Setpoint
Setpoints
External
Setpoint
Sub Menu Parameter
Motor Phase
Connection
Type
Motor Type
Motor
Service Factor
Amps
Min Frequency
Max
Frequency
Max Sensor
Sensor
Value
Unit of
Measure
Default
PSI 60 PSI
PSI 40 PSI
Unit of
Default
Measure
_ 1
– 3 wire
– Subm
A 00.0 A
Hz 30 Hz
Hz 60 Hz
PSI 100 PSI
Value
Min Max
Main pressure setpoint used. Sets
Max
main system operational pressure.
Sensor
This parameter is accessed here,
15 PSI Value
through PSI Preset button, or by
minus 3
pressing Enter button while in
PSI.
Constant Pressure operation.
Second pressure setpoint. When
another pressure setting is desired
Max other than Internal Setpoint.
Sensor Additional programming needed in
15 PSI Value I/O section. Requires an external
minus 3 switch or timer to wired to I1 or
PSI. I2 terminals. It is only active when
there is voltage present I1 terminals
(see Figure 11)
Max Min
Selects phase of motor to be
operated. An additional sub menu
1 3 will appear, based on phase
selection, to select proper motor
type.
Wire type for 1 phase motor
operation only. Can only access by
3 wire 2 wire
first setting Motor Phase parameter
to 1 Phase.
Motor type for 3 phase motor
Above operation only. Can only access by
Subm
Gnd first setting Motor Phase parameter
to 3 Phase.
Per Service factor amps (max. load) of
drive motor the Drive is operating. Sets
00.0 A
and maximum allowed amps at output
motor of Drive. See Table 7 for values.
1 below
Minimum frequency (speed) motor
30 Hz Max
will run.
Hz
Maximum frequency (speed)
1 above
motor will run. Up to 80Hz is only
Min 80 Hz
available on only when Motor
Hz
Phase is set to 3.
Maximum pressure value of
transducer sensor used with Drive.
10 PSI 300 PSI Only change if different transducer
is used with Drive, other than 100
PSI max scale.
15 15
Description
Description