Electrical Connection - Pelgrim IDK5104 Notice D'utilisation

INSTALLATION

Electrical connection

GB 24
Make sure the crossbar does not impede the airflow. Plane or saw the
crossbar C diagonally if necessary.
Do not allow a drawer to block the ventilation openings on the bottom
of the appliance. If there is a drawer under the hob, a gap of at least the
width of the hob should be made at the front. The distance between the
drawer A and the hob should be at least 10 mm.
For the connection, use an approved cable, in accordance with the
regulations. The cable casing should be of rubber. In case of faults,
consult the table on page 20 and 21. There is a label on the underside
of the appliance with the wiring diagrams. The connection terminals are
accessible once you have opened the junction box on the underneath.
The junction box cover can be opened with a screwdriver.
If you want to make a fixed connection, make sure that a multi-polar
switch with a contact separation of at least 3 mm is fitted in the supply
line.